Petroleum Engineers

  
Home | Petroleum engineering other to | Petroleum exploration engineer | Petroleum production engineeri
  Position：HOME>Petroleum refining engineering>Article Content
Effect of adding external stream to Crd Twr pumparound
Source：Internet Author：Unknow Pubdate：2008-04-15  
lgmarti (Chemical) 6 May 05 11:30
One of our HDS units is planning on routing their stripper overhead liquid to the crude unit top pumparound (@ the suction of the pump).  I would have prefered to route the stream to the slop tank.  However, the stream would then back out crude from the crude unit.  The stream is at 100F and it will be ~5% of the current pumparound rate.  Could anyone see an imminent problem with this arrangement?  ANy help is appreciated.  


（Click：）

Previous：Kinematic Viscosity and Density of LPG   Next：Air cooler fouling and cleaning methods
[Add TO Favorites] [TOP] [PRINT] [CLOCE WINDOWS]  
  Hot Article
·auto ignition temperature
·What is a flatolet?
·Material selection for higher
·ASTM D 1160 to TBP conversion
·High TAN Crudes
·what is "thermosyphon&quo
·Kinematic Viscosity and Densit
·Nelson complexity index
·Pyrophoric Iron sulfide
·Nelson Farrar refinery cost in
·Good refining literature
·Simulation softwares
  Related Articles
·Air cooler fouling and cleanin
·Corrosion concerns in gas coge
·Mercury in crude
·Can anyone use PipePhase
·Drifts and dynamics for a Spli
·gasoline fumes sensor
·NGL Mercury Removal
·High Acid No. in Crude
·Fuel blend calculation errors
·Inspection practice of FCCU ex
·Liquid hydocarbons from waste
·Olefins removal by Acid treatm
Power by DedeCms